Mirror Blades are designed to install directly against the inside of the cabinet of
your pinball machine. They are super thin, and install very easily. They are made of the
HIGHEST QUALITY STAINLESS STEEL material that can be sourced,
and Superior in the Market.

*** THE ORIGINAL - STILL BY FAR THE BEST IN QUALITY ***

 
                       
 
 
                                                               
         
                                                     
                                                     
                                                     
 
 

*** EXTRA NOTE:
All PDI - WMS Mirror Blades will also fit JJP and
New Reproduction Remakes from Chicago Gaming Machines !
!!

Check out below Installed Pix = Courtesy of Larry Schmidlin. =)


 
 
 
Mirror Blade Set
--- WMS / BALLY ---
$139.99
Mirror Blade Set
--- STERN ---
$139.99
Mirror Blade Set
--- SEGA ---
$139.99
Mirror Blade Set
--- DATA EAST ---
$139.99

   
 
                   
 
Colored - Mirror Polished Stainless Steel! NOT a COATING! MUCH more Durable and Reflective than other products currently in the market. We use a VERY Expensive Custom made material, that is mainly used in High End Architecture and Casinos.
STILL Very, Very Reflective!!!
 
       
     
   
BLUE Mirror Blade Set
--- STERN ---
$299.99
                 
Black Mirror Blade Set
---WMS / BALLY ---
$299.99
Black Mirror Blade Set
--- STERN ---
$299.99
     
 
 
                                                         
   
                                                         
       
                 
   
       
Gold Mirror Blade Set
--- WMS / BALLY ---
$299.99
                 
Gold Mirror Blade Set
--- STERN ---
$299.99
   
 
       
PRE-CUT Super Thin
Self Adhesive FELT STRIPS
   
Inlcludes 84 Inches of Pre-Cut Peel and Stick Felt Strips
Will fit both sides of your playfield - $19.99

 
Mirror Blade FAQ

Keep a few things in mind. Each machine is different, check to see how tight your playfield fits. These will make the fit more snug, but they are made of the thinnest possible material that can be sourced. Install these at the END of a restore job - not the beginning. Do not raise your playfield up and down more than is necessary, and when you do raise it carefully, slowly and centered to avoid causing surface scratches. Even if this happens, they are barely noticeable on this material, and far outweigh the alternative look of the factory black wood scratched out showing the different actual wood color underneath the black paint. You can also apply a thin felt strip to the sides of your playfield.

These make a HUGE difference in the overall look, enjoyment and experience of your machine. They install with provided tiny wood screws that run along the bottom and super thin strips of double sided adhesive tape for the top to keep flat. These are so thin the holes for the screws cannot be completely recessed, and the head of the screws stick out a tiny bit. In some cases this might also get in the way when you raise and lower the playfield. In this case, you can only use some of the screws and just the adhesive tape. The WMS / BALLY ones have a hole in the rear that the hinge bolt installs through and this also completely supports the back. They also come with quick and easy tips and instructions.